Nice anecdote ;-)
I understand your point of view pennpiper, and it was considered. However, this solution was finally chosen and applied to a special case as a safety precausion.
Thank you all for your advice.
The flanges have been drilled and the sensors are in place, each with a unique key.
Colorcoding wasn't an option, due to company regulations. It is a hot vessel, thus freezin is not very likely to occur. Corrosion can be, so inspections will be needed.
Hello all,
I have a set of temperature measuring instruments that are bolted into a pressure vessel using welding neck flanges, with a raised face. Specs: ASME B16.5 300 Pound 1.5" Carbon Steel.
I have a variety of these temperature probes, in order to avoid inserting the wrong one in the...
