This is the way I would do it.
In Autocad use the Helix command and draw 1 revolution, diameter x Height.
Then use list and it will give you all the information you need.
If you want a 3d model of the handrail, rotate the UCS and put it on the end point and draw a circle, explode the Helix just...
Hi, Gary
Got the answer to the problem from Autodesk, have just changed my model and it works.
Go to into the Content Centre Editor.
Right Click on the family and edit the family properties.
Go to the Parameter Mapping Tab and then to the Template Parameters within that.
Find the Hole...
Hi, Gary
Got the same problem with a flanged spigot. Pattern the holes in the flange, created an Ipart with sizes from 80nb to 600nb. When I click on the table all parts work fine, when I publish the part and insert one from the library, all I get is 8 holes which is the 80nb the 600nb should...
