Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by fcollins
-
Selection intent box in UG NX4
I lost the selection intent box for some reason. When I click extrude the floating selection intent box does not appear. I cannot select single curves or faces or any of the options usually available. I even went as far as uninstalling UG, rebooting and installing NX4 again. The box is still not...- fcollins
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
