Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by fauzi2015

  1. fauzi2015

    how to represent the feed rate as displacement boundary condition

    hi khalchris hope this link will help for ur case..they even providing the screenshot https://www.researchgate.net/post/What_is_the_best_way_to_apply_displacement_control_in_ABAQUS regards fauzi
  2. fauzi2015

    Modelling a Plate with sinusoidal Displacement Boundary condition in one edge

    hi imanhaji u can define the sinusoidal displacement by using amplitude (instead of ramp) in load definition. then just put u1=1 (if the displacement varies in x direction). regards fauzi
  3. fauzi2015

    contact problem

    hi afefdridi based on my exp, the displacement for time increment is too big message are coming from your contact definition. how do you define the contact? for excessive distortion of a total of 88 points in solid integration Continium message, this one usually can be eliminate by having...
  4. fauzi2015

    Contact problem between a tire and the road?

    gladiteur: pls check ur thread for my suggestion jcfhh: u are doing implicit or explicit analysis? for explicit, the adjustment automatically carried out when u start the analysis. as u are working from inp file..try adjusting/play with the minimum and maximum time increment. usually u may...
  5. fauzi2015

    Contact in 3D steel connection

    hi gladiateur u shall try surface to surface contact pair for the start. get the option for normal and tangential behavior(for friction if included for ur case). good luck!
  6. fauzi2015

    Contact problem between a tire and the road?

    hi jcfhh what is your minimum time increment set in step module? maybe the model needed lower minimum time to convergence. from the contact warning, abaqus try to tell u that node 43652 has excessively penetrating the model master surface, which will lead to convergence prob. i would suggest...
  7. fauzi2015

    excessive distortion

    by my experience, this excessive distortion prob can be reduced/eliminates by 1) first of all, u can see which node causing the problems by referring to job diagnostic(under visualization>tools) 2) try re-mesh the model, i would like to suggest to start from coarse to fine mesh, 3) somehow you...
See more

Part and Inventory Search

Back
Top