Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Fahadiqbal

  1. Fahadiqbal

    Parts List and Drawings discrepancy

    Thank you All. I would definitely ask before making a decision on purchasing the material.
  2. Fahadiqbal

    Parts List and Drawings discrepancy

    Thanks @CheckHater. Definitely will ask. @dgallup - no, we do not have any document like that. thank you.
  3. Fahadiqbal

    Parts List and Drawings discrepancy

    I have emailed the contact. However, is there any rule that we should always follow PL instead of drawing if there are discrepancies? My manager stated "PL always takes precedence over drawing" but i am not sure. Thank you.
  4. Fahadiqbal

    Parts List and Drawings discrepancy

    Hi All, Just a bit confused on a drawing. Drawing has a thickness of 0.070" and Part list states 0.125". Material is Teflon which in Aerosapce industry is not available in 0.125" from approved sources. Will I be okay to use the thickness as shown in drawing or does PL always supersedes...
See more

Part and Inventory Search

Back
Top