Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by fabuara

  1. fabuara

    Aboveground ammonium nitrate belt conveyor water deluge system

    Very grateful UFT12, I did not obtain any relevant information on Ammonium Nitrate FM DSs. I will try to find my way through the Insurance Company.
  2. fabuara

    Aboveground ammonium nitrate belt conveyor water deluge system

    I am involved in the design of a deluge system for an ammonium nitrate "aboveground" covered conveyor belt at a fertiliser plant. As it is HAZMAT, I consulted NFPA 400 (11) which, for such purposes, refers to NFPA 13. However, NFPA 13 specifies the use of sprinklers for this purpose but is...
  3. fabuara

    Deluge system for a spherical pressure vessel of anhydrous ammonia

    Thanks for reply MJCronin. I guess I was not clear enought. In fact, it treats of an existing pressure vessel that has a spraying system with 2 HV-45 sprays at the top and 2 more at the bottom of the vessel (if no cooling system is required for the sphere, may be it was designed to fight...
  4. fabuara

    Deluge system for a spherical pressure vessel of anhydrous ammonia

    Thanks Stooketfpe. I'll provide these standards.
  5. fabuara

    Deluge system for a spherical pressure vessel of anhydrous ammonia

    I need size a deluge system for a spherical pressure vessel of anhydrous ammonia of about 820 m3 wich should to be protected by water spray, but I can not get the right information on the design of such systems. I consulted NFPA 55 but understood that it is limited to "occupancies" and in my...
  6. fabuara

    The best way to arrange a discharge header

    In the case of a discharge header of a system of pumps in parallel (a total of five centrifugal pumps in the present case), must the outlet piping to the process be positioned after the last pump or can it start immediately before the last pump? By adopting the last arrangement, would there be...

Part and Inventory Search