Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by express2

  1. express2

    Hardness survey requirement to NACE MR 0175.

    Dear Experts, Please advise on below query. Applicable codes are; ASME Section IX NACE MR 0175. We have one WPS Qualified in butt joint and Hardness survey done according to NACE MR 0175 (7.3.3.3 Figure 2) on Butt weld coupon. ​Is it correct that we cannot use the above WPS in a fillet...
  2. express2

    WPQ coupen thickness beyond the range qualified by WPS.

    Dear experts, Please advise on below query. Ref Code: ASME Sec.IX Thickness range qualified in WPS is 5- 22 mm if there is a necessity, Can i conduct WPQ and qualify a welder on 4mm or below thick plate using above WPS Rg. Bas
  3. express2

    BSEN 10204 type 3.2 Certification.

    Dear All Please clarify my below query. A- Pipe manufacturer B- Trader C- Valve Manufacturer D- EPC contractor E- Owner. 'C' Procured a pipe from 'B' to manufacture a valve and then supplied to 'D' which is going to be installed at the location of 'D'. The Material requires BSEN 10204 type...
See more

Part and Inventory Search

Back
Top