Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by EvoSteve

  1. EvoSteve

    Is it legal, advised, to use defined surfaces and multiple surface profiles as one datum as shown in

    Thanks for your quick response! The file is a Word document, but as suggested having the "&" symbol may be a show stopper. The new document is a PDF file, and of course there is no "&" symbol. Again...
  2. EvoSteve

    Is it legal, advised, to use defined surfaces and multiple surface profiles as one datum as shown in

    A circuit board, shown below, needs to fit into a plastic housing. There are no datum holes in the PCB and the outside of the PCB will be used to register it inside a plastic housing. The PCB sits on shelves in the plastic housing, as indicated in the pictures. The plastic part has small ribs...
See more

Part and Inventory Search

Back
Top