Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by evanhem

  1. evanhem

    Making a tube through a hole.

    I am trying to make a through tube that ends at a hole. I have tried making the hole and then making the tube and I get "Unable to perform Boolean". I have tried making the tube and then making a hole/cylinder/extruding a circle through to the tube face and I always get "Tool and Body do not...
  2. evanhem

    See-Thru Shell View Command Not Activated (NX 7.5)

    Great, I just figured this out. Added the See-Thru command to my toolbar. Thanks John.
  3. evanhem

    See-Thru Shell View Command Not Activated (NX 7.5)

    OK, I found the 'See-Thru' command in the command finder, and the button now works. But how do I toggle back to the old mode?
  4. evanhem

    See-Thru Shell View Command Not Activated (NX 7.5)

    John, Sorry for my ignorance, but is there any way I can turn on 'See-Thru' display mode then? Thanks for your help.
  5. evanhem

    See-Thru Shell View Command Not Activated (NX 7.5)

    John, Thanks for your response. Please see the attached image. http://imgur.com/aQnELlI
  6. evanhem

    See-Thru Shell View Command Not Activated (NX 7.5)

    My favorite view in NX occurs whenever I try to make a hole. This is my favorite view by far. I suspect that this view is the "See-Thru Shell" view. Unfortunately, this view button is not activated in my NX. Any ideas? Thanks.
See more

Part and Inventory Search

Back
Top