Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Europeeng

  1. Europeeng

    Blast Load Shape Factor Vertical Vessel and Chimney

    Hi Does anyone have a reference to shape factor for blast load analysis for vertical duct?
  2. Europeeng

    Nozzle loads for Leg/Skirt calculations in PV-Elite and Reinforcement pad

    Hi. See attached figure. I want to add a horizontal Nozzle load, but the loads is not added to the Leg/skirt calculations. Is there a solution for this in PV-elite? Is it possible to add a reinforcement pad on the Ellipse head as shown in the figure?
  3. Europeeng

    PV-Elite Local Loads applied at end of Nozzle

    Hi, Yes, it is possible to apply the load at the nozzle end. In the setup menu there is a option for this.
  4. Europeeng

    PV-Elite Local Loads applied at end of Nozzle

    Hi, How do I apply the nozzle loads at the Nozzle end in PV-Elite? I can`t find this option.
  5. Europeeng

    PV-Elite flat bottom tank

    dig1, yes I use the EN 14015 for tanks but i want to solve this with PV-elite. Is it possible to design a vertical vessel in PV without bottom skirt, and use the reaction forces to calculate the support in detail? Loads will esentially be, Nozzle loads, wind loads, pressure and water filling.
  6. Europeeng

    PV-Elite flat bottom tank

    Hi, Is it possible to analyse a vertical vessel/tank without skirt in PV-Elite? I want to analyse a vertical vessel with flat bottom and bolted connection to a concrete base according 13445.
See more

Part and Inventory Search

Back
Top