Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by esoxlee

  1. esoxlee

    Mold Draft Tools - AutoDesk vs NX7.5

    Thanks for the reply. I was curious to know if one was more accurate than the other. I'm in the process of designing a large injection molded part with NX7.5 and I'm using the built in draft analysis tool. However, the engineer at my supplier is using AutoDesk. If both are about the same, it...
  2. esoxlee

    Mold Draft Tools - AutoDesk vs NX7.5

    Hi: Haven't posted for quite some time. Was unemployed for almost 2 years. Which is more accurate when running an injection mold draft analysis, Autodesk or NX7.5. My plastics supplier is running the draft analysis using a model within AutoDesk and I'm running the analysis using NX7.5.
See more

Part and Inventory Search

Back
Top