Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ernie7
-
How to enter fractions ?
If you want to draw a line, say 2 1/2 long at a 45 degree angle, from any starting point enter: @2-1/2<45 Or the diameter of a circle enter: 2-1/2. You cannot use a space line 2 1/2 because the computer sees 21/2 You nee the - to seperate.- ernie7
- Post #2
- Forum: DASSAULT: DraftSight
-
Model space lock/unlock
When in Model space, I try to lock that is supposed to prevent the drawing from changing. But wether I lock or unlock, the lock is always checked.- ernie7
- Thread
- Replies: 0
- Forum: DASSAULT: DraftSight
