Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ermine
-
Polyethylene Creep
I am looking for data on polyethylene creep specifically for LLDPE. Any data would be appreciated. Thanks.- Ermine
- Thread
- Replies: 3
- Forum: Material engineering general discussion
-
Bend Line Note
I have changed that file, but SW will not calculate the bend if it is up or down. The file reads: <bend-direction-up> = UP --> I want it to say: <bend-direction-up> = BEND @ 180-<bend-angle> Is there any way to do this? Thanks.- Ermine
- Post #3
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Bend Line Note
Is there any way to edit the bend line note in Solidworks to display for example: BEND @ 135 instead of BEND UP 45 BEND @ 225 instead of BEND DOWN 45 This thread asked the same question but it was closed. thread559-150501- Ermine
- Thread
- Replies: 2
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Isometric view creation
Is there any way to create new isometric views like AutoCAD used to have i.e. nw isometric, sw isometric, etc.? Thanks, Jason Wilger Schulte Industries Ltd. jwilger@schulte.ca- Ermine
- Thread
- Replies: 1
- Forum: DASSAULT: SOLIDWORKS 3D Design
