Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Engr.marzan

  1. Engr.marzan

    Reaction Values Displayed Despite No Restraints ETABS

    Thank you slickdeals. No There was no restraint in the YZ plane in the active degrees of freedom. i already attach that file. The issue was resolved after deleting and redrawing the wall. I believe it was a glitch.
  2. Engr.marzan

    Reaction Values Displayed Despite No Restraints ETABS

    sticksandtriangles YES i hit apply option when wall selected and also check Wall meshing option.
  3. Engr.marzan

    Reaction Values Displayed Despite No Restraints ETABS

    I created a 1x10 ft wall in ETABS and assigned a non-uniform load starting 2 ft above the base. However, I'm encountering an issue where ETABS shows multiple reactions at mesh nodes where I haven't assigned any restraints. I've only assigned fixed supports to the two end nodes at the base, and I...
See more

Part and Inventory Search

Back
Top