Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Engkata
-
Curve selection
It is NX11, just with a company setup, what makes the oldschool look. It has also the Point in region possibility, but due to a more complex shape (not like in my sketch) it takes 20 minutes to detect the region, and in many case it is not able to keep the contour.- Engkata
- Post #3
- Forum: Siemens: UG/NX
-
Curve selection
Hello! I am struggling with the curve selection. There is a long region what I want to hatch in multiple section, and for this I need to select the boundaries. If I do it with "stop at intersection" it takes too long time. If I select it as a connected curve, it selects the complete region. Do I...- Engkata
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
