Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by engbob826

  1. engbob826

    Calculations of a welded joint consisting of a fillet and bevel groove

    Metengr & rjenson, So if the fillet only is worth 172 kips at E70, and the chamfers leg is approximatly .9" which gives 184kips. Would my total load capability be 172+184=356kips? I was thinking the worst shear area is the hypotenuse of the chamfer which is appoximatly 1.375" would then give...
  2. engbob826

    Calculations of a welded joint consisting of a fillet and bevel groove

    We manufacture towers posts with round base plates (made from T1) welded to the ends. The posts are 4" in diameter solid shaft at 55ksi and beveled at 45 degrees making a 1"X1" bevel. The posts are then welded filling the bevel followed by a 11/16" fillet. The posts are capable of taking a...
See more

Part and Inventory Search

Back
Top Bottom