Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ENG331
-
Part Marking
If these are welded ASME grade parts - a coded marking system is easiest. Eg Pipe - mark sequentially P1, P2, P3.. Mark the coded marking system on the MTR that comes when the material is recieved. When receieved MTR should be checked against code for compliance to dimensional, and chemical...- ENG331
- Post #3
- Forum: ASME (mechanical) Code Issues
-
AS1210 Coupling / Flange temp-pressure ratings
I am looking at AS1210, and am having trouble interpreting the language of the code. I have a coupling issue, and a flange issue. I am looking at 3.19.4, referring to screwed and socket weld connections. I have a heat exchanger, where I am wanted to put a coupling (B16 3000#) operating at...- ENG331
- Thread
- Replies: 1
- Forum: ASME (mechanical) Code Issues
-
1971 ASME Section VII, Div. 1 allowable stress values
1971 ASME Section VIII, Div. 1 SA240TP 316 Plate at 200 and 300 F - both high(@ both temps 18.7) and low values please (@200 18.7, @300 16.1) SA240TP 316L Plate at 200 and 300 F - both high(@200 and 300 -15.6) and low values please(@200-13.2, @300-11.8) It is not listed under TP, that is...- ENG331
- Post #2
- Forum: Boiler and Pressure Vessel engineering
