Hi everybody.
I'm dealing with a heat conduction problem right now. I've found an analytical solution to it using variable separation and all that stuff. But, there's many constants and too few information for boundary and initial conditions.
Because all this, i wanna compare my results with...
Oh no, no. That 2,8 was a mistake of mine while writing my thread. I was trying to write 0,38 but for any reason it slipped. Thanks mihaiupb. By the time i'm thinking that maybe i don't get any result because the loads in my model doesn't left much degrees of freedom... maybe.
By the other...
Thanks mihaiupb and cbrn for your good will. But sadly there's no solution to my problem by the time. I've tried to import my model from a CAD software, make it with ANSYS using different dimmensions, and i've tried too by changing the units at the time i'm defining my material, but there's no...
Hi again everybody.
As usual, the way ANSYS handles units is a good source of confusion. In my model i'm asuming that my dimensions are in meters, so if i have to input a node coordinate in (1x;2y) milimeters, i input (0.001x;0.002y) for being consistent with my units. But when i'm defining the...
Hi everyone.
I'm stuck in a design problem and i can't make any advance just because i don't have this little data: Poisson ratio for Bakelite (or phenol-formaldehyde).
If anyone knows about a book or a web site where i could find this fact, please make me know about it. I'll thank you very...
I'm trying to use ANSYS 9.0 in a modal simulation. My study object is a mechanical component created with SolidWorks 2006 SP0.0. I've instaled first ANSYS, made sure that it was working and then instaled SolidWorks. But after doing that (installing SW) ANSYS doesn't open and displays this dialog...
