Recent content by eli215

hi all, I am searching how to create bondary coditions with "ground spring". I would like to evaluate the influence of the stiffness of a fitting by varying the stiffness in certain directions. Thank you

when we create composites layup, what is the difference between conventional shell, continium shell and solid ? thank you in advance

i have a problem just in "property Module"

can somebody indicate me the stages for the modeling of composites in abaqus? regards

hello, which configuration for a laptop i need? We want to simulate essentially a 3D composite wing for damage, fracture, delamination, heat transfer.... Any help is much appreciated. Thanks.

hi Is there a documentation for modeling of the composites structures with abaqus?

hello, try this: Tools >query, general queries i hope that help you.

Use "Render model: Wireframe" in the GUI to select these region for meshing. regards

you're wright for the area that has a very small curvature. i try to use small mesh size. thanks.

hi, i try to mesh my model but i also have this warning : "Some of the mid-edge nodes were not projected onto the geometric boundary, in order to avoid forming bad elements". i don't know how to avoid it. thanks in advanced for your help

thank you very much.

element type: C3D10, Tet

in the same study, i have an other warning for mesh : "3 elements are distorted. Either the interior angles are out of the suggested limits or the triangular or tetrahedral quality measure is bad. The elements have been identified in element set WarnElemDistorted."

thank you vumat721.

Anyone to help me ?