Recent content by el124

Hello, I started working for a company almost for 2 years now. In that time, I studied for a test to the next progression in that field. When I took the test when the job was available, the study material(a sample test) online that was given did not fully coincide with the actual test...

Dont want to be an engineer but do want to be a tech? Any advice on what employers look for in new grad electrical engineering techs?

I will be graduating with an Associates Degree in Electrical Engineering Technology this August and would like to know what employers typically look for in recent graduates? I have an Associates in Radiological Technology and have 8 years of experience working in the medical field as an...

I know the emulator does not exist, that is why I am asking If I am using the right version?

I tried the steps above but whatever the reason, RSLogix still comes up with. (Node 1 not found) and proceeds up the list. node 2, node 3, and so on....It still does not go online. Are there any other steps that I may need to do to go online?

Which version of RSLinx should I be using? I have v2.54 I tried the DH-485 but Im not sure its the same one? The only drivers I have are....http://files.engineering.com/getfile.aspx?folder=0b1caba3-1680-4e63-baa4-d9f2ed0e128c&file=Drivers.doc

I have tried using a few of them but none of them seam to work. I included a couple screen shots. Not really sure which driver I should be using? I tried a few, some of the nodes are found others are...

I gave it a shot. The communications window freezes after that and does not respond to rslogix micro. Error message: (Diagnostic status failed: 0xFFFFFFFE)

Hello, I have Vista as an operating system and have been trying to set up RSLogix and RSLinx. I can get as far as writing the ladder logic and verifying the program, but I am not able to go online and run the ladder program. I get an error: (No response from processor at selected path/node!)...