Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ejthoma2
-
Roundness vs diameter for Tolerance Stack
It's okay - these are solid steel components. Definitely rigid!- ejthoma2
- Post #8
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Roundness vs diameter for Tolerance Stack
Fantastic - thanks guys!- ejthoma2
- Post #6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Roundness vs diameter for Tolerance Stack
Thank you! That helps! :) So - on the drawing of the cylindrical component, should the roundness be adjusted so that the tolerance is not greater than the diameter tolerance?- ejthoma2
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Roundness vs diameter for Tolerance Stack
For tolerance stacking an assembly which includes a cylindrical component with both a diameter tolerance and a roundness tolerance, how do the two tolerances combine within the tolerance stack? I assume it would be best to just use whichever is largest, but opinions would be most welcome! Thanks.- ejthoma2
- Thread
- Replies: 11
- Forum: Drafting Standards, GD&T & Tolerance Analysis
