Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by edomad

  1. edomad

    NX3 How to draw grooves in the inside of a cilinder?

    I have problems to realize the groove of the figure that I attach above. The piece have 8 grooves of diameter 4 mm and inclined to 45 degrees Someone can help me how can i do it in NX3? http://www.geocities.com/mad29jp/help.html?1131723447321 http://www.geocities.com/mad29jp/disk_drive.html...
See more

Part and Inventory Search

Back
Top Bottom