Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by eddiesk

  1. eddiesk

    shell edge load problem

    First of all, thank you for your answer. I'm glad it was you who responds. But even if partition it i can't apply the load.If i extrude a little circle it 'll not change the results 'cause i'm working on shell ? Thank you
  2. eddiesk

    shell edge load problem

    Hello , i have a very simple probem to model.you can see the attachement. I can do it in 3d without problem ,but in shell ELEMENT when i select shell edge i have this message: "regions must contain only free shell edges".I partitioned the model correctly. Any suggestions to solve the problem...
  3. eddiesk

    inp file for an easy problem

    hello , I think i have many problems in my model.It's makes me crazy because i think it's an easy problem :s I'll describe what I did. I drew the shell part in solidworks, after that i imported it in Abaqus.(I ran the simulation in Solidworks and it works , i have to verify my results in...
  4. eddiesk

    unconnected region

    it's a single part !
  5. eddiesk

    unconnected region

    hi , i'm working in a project in abaqus.I imported a geometry from Solid works. I have an error message :THERE ARE 26 UNCONNECTED REGIONS IN THE MODEL.I don't know wich regions are unconnected. My question is :how can i see these regions to redfine the contact ? i'll appreciate your help...
See more

Part and Inventory Search

Back
Top