Hey, thanks Mint,
That's a lot of information!
I was finally able to put together a chart that meets my needs, it is quite simply:
THREAD PITCH/PLUG DIA
80/.031
64/.031
56/.046
48/.046
40/.062
36/.062
32/.062
28/.093
24/.093
20/.125
18/.125
Once again, thank you for all the sources.
Hi Mike,
There are definitely requirements. I have a very old and fragile document but very little of it is legible.
I can only make out two of the entries:
THREAD PITCH PLUG DIA
80 .031
32 .062
That's all I've got.
I am looking for a specification, standard or industry guidline that documents the required diameter of a lock plug based on thread pitch.
Can someone post a link to a site where I can view or down-load a chart or document?
Thanks in advance
