Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by eceg

  1. eceg

    3 Phase motor getting hot.

    I'm so sorry all. I was bit busy and didn't have the chance to post the name plate of the 2 motors. It's GUSHER pump. Model : 11201-XLONG Serial : 1203-260 Volts: 230-460 AMP: 1.6 - 8 HP: 1/2 RPM: 3450 CY: 60 Ref: 34G61 - 3229S2 IMP 2281 - B I just checked the amprage of the wires using clamp...
  2. eceg

    3 Phase motor getting hot.

    I just replaced same type of motor, same serial #, RPM, HP, everything the same. I got this motor from the manufacture.Before I diconnect the wires, I even wrote down the connections as low voltage connections.I connected the same wire connections on this new motor. It runs for about 15-20 min...
  3. eceg

    Microwave Help

    I guess I posted my thread in the wrong forum and then my thread got deleted. I was just hoping that instead of deleting my thread the mod could have move the thread to the right section of the forum, because I guess a lot of us here sometimes missed read, time consuming, not knowing, etc...
  4. eceg

    AC Motor is Humming, Vibrating

    I took them apart, cleaned inside housing using electrical contact cleaners, sand the all electrical contacts, checked all connections. Put back everything, power it up, voila......this time it spins as soon as I turn ON the switch. :) Once again thanks fr the tips Waross. By the way...
  5. eceg

    AC Motor is Humming, Vibrating

    Thanks for the tips. I checked the switch when turn ON, yes there's current. Dissembled the motor and cleaned inside. Yes I see some corrosions. I used air gun to blow it out. Put back everything, still the same results. Humming and vibrating. I still hear the click Do you know the place or...
  6. eceg

    AC Motor is Humming, Vibrating

    Hi All, I'm trying to figure out why the ac motor that I'm working on is giving a humming sound, vibrations when I turn ON the power switch. I have to give it a kick or a pushing turn to help then it runs fine. When I turn the switch to OFF position and when it stops spinning, I can hear the...
See more

Part and Inventory Search

Back
Top