Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ebbal

  1. ebbal

    Drilling & tapping an elbow for relief valve

    Looking at the pic, it appears that the PRV is 1/4". Assuming that, I believe the would be suffient thread to achieve a good seal. I have seen PRV's put on fuel lines on the suction side of pumps for the exact reason you stated. If on the discharge side of the pump I would require an internal...
See more

Part and Inventory Search

Back
Top Bottom