Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Eagle
-
Bonding of two Delrin (Dupont) parts
The adhesive joining of DELRIN acetal resin is generally limited to prototype parts with low shear forces. This is because the shear strength achieved with most adhesives is only 2 to 10 percent of the available shear strength of DELRIN. The best adhesion requires a special roughening step...- Eagle
- Post #2
- Forum: Welding, Bonding & Fastener engineering
-
Iges File Translation
Try using 3D Actify program. Provides excellent viewing and measurement capabilities. They used to offer free 30 day use of program. Not sure if they still do...worth a try. www.actify.com Good Luck- Eagle
- Post #6
- Forum: Mechanical engineering general discussion
-
Sliding Nylon 6/6 on chrome plated ring
You may want to obtain a free book from Laird Plastics. It has much of the information you are asking. 800-610-1016. Also contact manufacturer of plastic and request their design or engineering guide. Note that nylon has high moisture absorption....could affect your clearances and thus...- Eagle
- Post #2
- Forum: Welding, Bonding & Fastener engineering
-
Engineering Change Request (ECR) Software
Chris, Try researching DataWorks. They handle the entire process.- Eagle
- Post #2
- Forum: Mechanical engineering general discussion
-
Center of gavity of a person
Saint, You could look at the Human Factors Design Handbook (McGraw Hill) Chapter 4. There are also computer programs that allow you to position the body and even import your CAD data. I'm familiar with Mannequin by HumanCAD but there are others. Hope this helps Herb- Eagle
- Post #2
- Forum: Mechanical engineering general discussion
