Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by dwyer

  1. dwyer

    Pressure drop and flow rate calculation, help?

    TD2K, Thanks for the information. The following is a copy of the question that was sent to me. "I am looking for information on a crane 382P valve. It is installed as a bypass around a pressure reducing valve, and I need to know the maximum capacity of steam it could pass. The valve is...
  2. dwyer

    Pressure drop and flow rate calculation, help?

    Hi, I have a question regarding pressure drop and flow rate in a steam line. I have an existing steam line with a 100 psig at inlet and 12 psig at oulet of a pressure reducing valve. I need to figure out what is the maximum flow fate across a wide open globe valve if the pressure reducing...
  3. dwyer

    valve minimum wall thickness

    Thanks for replying to my question. However, I do not have access to the DIN 2840 standard or even the ASME B16.34 code. Are these available online or is it possible to send me a copy of the section that pertains to valve minimum wall thickness. Thanks, Dwyer
  4. dwyer

    valve minimum wall thickness

    Hi, I am trying to calculate the minimum wall thickness required for a check valve. I am using the formula from ASME B31.1-1995 edition, "minimum wall thickness for a staight pipe under internal pressure", Paragrah 104.1.2. I want to verify some valve designs done in the past. Is...
See more

Part and Inventory Search

Back
Top Bottom