Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Dunme

  1. Dunme

    Welding inside 18" and 20" Diameter pipe

    I have a situation on one of my sites as the contractor was found welding inside a 20" pipe. The weld point is 2.7m from the edge of the pipe while the other end is inaccessible due to installed ISO Bundle. This in my view is an unsafe act, However to advise the contractor on the issue I am...
  2. Dunme

    Welding inside 18" and 20" Diameter pipe

    Gents, I have a situation on one of my sites as the contractor was found welding inside a 20" pipe. The weld point is 2.7m from the edge of the pipe while the other end is inaccessible due to installed ISO Bundle. This in my view is an unsafe act, However to advise the contractor on the issue...
  3. Dunme

    Overhead crane repair works.

    Does anyone known what procedures are to be followed in the repair of a damaged crane girder before installation?
See more

Part and Inventory Search

Back
Top Bottom