Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by dtm247
-
Countrsink lead-in for internal threads--is there a std?
thread404-137155 We typically use a 90° spot and edge break requirement noted on the print. For example, M10x1.5 has a max major of ~10.4 and if the edge break requirement is .1-.5mm, we will have a chamfer diameter of Ø10.5-Ø10.9mm to satisfy the requirement.- dtm247
- Thread
- Replies: 1
- Forum: Mechanical engineering general discussion
-
NX 9 Hidden Lines
In drafting, the hidden lines will not show up for countersunk holes. However, if I bring in a model not created in NX9 it seems to work correctly. http://tinypic.com/r/2ugl7c5/5 http://tinypic.com/r/2iaa3i1/5- dtm247
- Post #3
- Forum: Siemens: UG/NX
-
NX 9 Hidden Lines
Anyone having trouble with hidden lines in NX 9? Hopefully if this is an error it will be fixed in the next update....- dtm247
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
