Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by drsmith01
-
circular run-out vs perpendicularity
There is a debate going on in my office about weather to use circular run-out or perpendicularity and I'm looking for some help. The part is a simple cylindrical stop post for a die set. I believe that circular run-out of the ends of the post to the cylinder give the machinist the most freedom...- drsmith01
- Thread
- Replies: 1
- Forum: Drafting Standards, GD&T & Tolerance Analysis
