Hi All.
I'm in a Canadian military warehouse. The floor, support columns and roof seem to be one piece. The floor is 8 inches thick (at least in the place we drilled)
The building was built in 1951. I have most of the drawings but not the foundation ones.
How can I find out if there is re-bar...
Hi All.
I'm trying to figure out where to start so I can figure out what I need to do to support some tanks on a warehouse floor.
It's an old Canadian military warehouse with a poured concrete floor and ceiling. Unfortunately we can't get any information on the floor since some of the original...
Hi All.
I need some ideas on how to support some large horizontal tanks. The area of the two saddles (13'6" by 10") that the tanks sit in give a ground load of 17,800 lbs/ft2.
Since the tanks may not be in place for very long I'd like to stay away from concrete footings.
The spot that I'd...
Good morning
I need a ramp to be able to drive a tractor trailer into a building through an existing dock level door. I need to get 40 foot tank trailers as well as B-trains into the building.
Is there a formula that I can use to make sure that the landing gear doesn't hit the transition...
Hi All.
I'm looking for two formulas:
1. The number of tubes that can fit in a given circular arrangement similar to a boiler.
2. The length of tubing needed to form a coil.
Thanks in advance.
Good evening all.
I'm trying to figure out how to calculate the theoretical amount of water needed to remove a given amount of methanol and soap from biodiesel.
I don't know if these are the right questions but:
What is the saturation point of methanol in water? Is it temperature dependant...
