Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by drolds

  1. drolds

    Straightening 4140

    The material is pre hardened before machining. It is 28-32 Rc at delivery. It isn't a big deal if I can't straighten it as the parts will pull down straight at assembly. Noel
  2. drolds

    Straightening 4140

    I surface ground the parts flat within .001 bfore I machined them.I will probably talk to our heat treater on tuesday and see what he sugestes. Noel
  3. drolds

    Straightening 4140

    here is a pic of the part.I would be happy if I could get it flat within .002".The steel is 29Rc Thanks Noel
  4. drolds

    Straightening 4140

    Hi I am new to this forum and am seeking advice on the best way to strighten 4140 Ht. I have so parts that have been machined and have bowed .015" ove 24". Is there a way to straighten this without heat. The thinest part is 3/4" and the thickest is 1.5". Thanks in advance...
See more

Part and Inventory Search

Back
Top Bottom