Recent content by drilling53

thanks for the note, as said in my previous post I have verified the results from Prode Properties with the values reported in that paper, appendix a the columns for 600-Step Numerical Integration, as I understand, Prode adopts a 5 points integration method, which I have verified to be very fast...

PaoloPemi, thanks, I have verified the accuracy with the reference method discussed in the paper, to obtain the same values (calculated with the integration method in Prode) the reference method requires hundred of small steps... and much more time, rotw, I calculated the values with the...

I am evaluating compressor performances comparing results from different models in Prode Properties, I am mainly interested to compare high-accuracy Helmholtz-energy models ( GERG 2008 ) vs. three parameter corresponding states ( Lee Kesler Plocker ) vs. virial models ( Modified BWR ) As...

thanks georgeverghese.

Hans, I did the test, the method StrRVP() for calculating Reid Vapor Pressure extracts the liquid fraction (if I include fractions which are vapor at 0C atm) before to simulate the ASTM D323 procedure, do you have an idea about the possible errors with this procedure ?

I have a question about Reid Vapor Pressure as calculated by Prode Properties, the manual says the software simulates the ASTM D323 procedure, my question is about composition to enter, is that of liquid phase or the stream composition ? Thanks.

if you have doubts call the vendor asking to explain :-)

thanks !

which thermodynamic models should I select in Prode Properties for calculating the phase diagram of a mixture with hydrocarbons + water + methanol ? Thanks !

Rense, I agree that for specific applications one should ask the manufacturer but, as said, I cant' get support and I need to verify a few cases for two phases flow, thank you for your suggestion to get the Excel page for control valves from Prode (I didn't know there was a specific application)

do you have experience with HNE model available in Prode Software when applied to control valves (two phase flow) ? I have some cases where the usual ISA formulations seem to produce unreliable results (revamp of existing plant) I have data sheets and drawings but valve manufacturer is no longer...

does MATLAB 32 work in Excel 64 with PRODE Properties process library ? I have recently upgraded to Windows 64 and cannot run the vapor-liquid phase envelope m file.

could it be the Gas Processors Association ?

the basic components of a JT skid (pressure reducer + separation) are parts of std. plants, the heat exchanger can improve process efficiency but not too much according my experience, to effectively control the dew point I think a chilling plant (mechanical compression) would be much better, but...

the result (80->50C) would be a reduced density, velocity and pressure drop