Recent content by Drhinehart

When I get fail to save error it is usually when I am using configurations. To fix the problem I open each configuration and do a force rebuild "Cnt'l Q" then I am able to save the file as normal. If you are not using configuration do not know if this will work for you.

Has anyone else experienced any issues printing to Xerox printers? In particular everything prints except the object lines?

Thanks.. I knew that was what it was just could not locate it. two of us overlooked it 3 times.

When I add a dimension to a drawing the dimension name is showing up in parenthesis below the value. Can someone please help and tell me how to turn this off? SolidWorks 2008 SP2.1 Thanks.

Is there an easy way to make the standard holes call outs to place the qty at the end of the call out by default and add parenthasis?

Does anyone know where I can get a prgm that will generate and Excel BOM without opening the assembly?

Cadman, that is exactly what the problem is... Limey, I think your suggestion might work the best. Tell the designer if they are haivng trust issues then they need to create the flat pattern before releasing to detail. thanks for the input..

I have started at a new company and it is more sheet metal based than where I was at before. with that being said, we are experiencing some issues with the trying to create the flat pattern on the detail drawings. We have designers and detailers and the designers do not want to give the...

I did this back in January and it worked. Can't recall exactly what I did we were using 2005 and since we upgrade to 2006 it appeared to work differently. Can anyone verify that this works in 2005?

Don't worry I am in the same boat... I have done this before just having a hard time remembering the process to get waht I need. I am working with the sweep option right now... Maybe it's just time to go home and start over in the morning.

Thanks for the help... I think a sweep is going to be the way to go with this.

Were would I find draft option?

How do you wrap a sketch and have it cut through with out a tappered hole? I have a pipe I need to place a cam-lock onto. The cut needs to be straight. I have done this before SW2006 but I am banging my head trying to figure out how to do it again. The slot starts at 90 degree then goes...

Just received a new system and looking for advice on settings that will help get the most out of what has been purchased. System: HP xw4300 3.4 Ghz P4 H/T Nvidea Quadro FX4500 512mb 2gb Kingston 4200 Ram Win2000 Dual Monitors In particular I am looking for optimal settings for the video card...

I have been experiencing the same issues with trying to place Ballons on assembly drawings. It almost appears like the selection is jumping around and you have to time your mouse click when an edge is highlighted. The solution that works for me is like Limey suggested and use the selection...