Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by dpwalker

  1. dpwalker

    GD&T in the tolerance block

    Here is the tolerance block. The design group uses this as a standard including drawings for labelshttp://files.engineering.com/getfile.aspx?folder=a91aeeb9-e06b-4566-9233-b0de8ab59377&file=tolerance_block.bmp
  2. dpwalker

    GD&T in the tolerance block

    Thanks. Your reference says it should only be applied to surfaces by putting it in the block tolerance it is applying to all dimentions there are no othere tolerances in the block so it applies to everything and therefore is incorrectly applied -- correct?
  3. dpwalker

    GD&T in the tolerance block

    The Design Group at my current company is using GD&T in the block tolerance. Not the normal plus minus tolerance but a statement that all dimensions are basic and uses a profile tolerance for all dimension tolerances. I have never seen this in past companies. Is this a generally accepted...
See more

Part and Inventory Search

Back
Top