What are the nuances to the terms principal/principle (I don't know which is supposed to be the proper spelling, but I have seen both) engineer vs lead engineer vs engineer?
You have good timing. I just learned how to do this today. The Solidworks Help was great. You can use the Index for the word Planes- and on the top of the list is "at angle"
Then you can click on any of the titles that are in green on the help page to find out step by step details.
I love...
Hello,
I am trying to save a drawing file as a pdf form using the add in in Solidworks. Unfortunately, it cuts off the edges of the document. Can someone share a quick solution to this problem?
Thanks
Hello,
I am trying to model a constant strain rate test. My model is very simple block with the bottom area held constant and a load placed on the top area. I tried a constant displacement load but it changes the strain rate considerably over the loading time- which is understandable- but...
Hello,
I am tried running a bash file using the same layout as in the help file.
When I call ansys70 (with several of the different tags) I get a message that says: "Checkout failed for the above prouduct Flexlm error message: License does not support this feature." Does this mean...
Hello,
I would like to run a set of independent input files in ANSYS consecutively. Can anyone explain how to do this? I found the help in the Ansys manual a little confusing.
Thanks for your help,
Debbie
I have received this message before. It is usually caused by the mesh being too fine. (I, too, am using the educational version) Try making the mesh coarser with larger element size.
If you are considering moving to Lindows, you should also check the compatability of your hardware. They make specific drivers for Lindows that are different than the ones that Windows uses.
I have never used Lindows. But I have used Gnome and KDE and I can tell you that the mainstream...
Hello,
I am trying to perform a CTE mismatch analysis. I am trying to figure out which command to use to apply a higher temperature to the entire model (i.e. what happens when an oven and specimen reacha steady state temperature). I want to see the displacement caused by the temperature load...
Hello,
I am trying to draw a machine drawing of a three dimensional object using Autocad R13.
Is there a way to draw lines with a hidden linetype in one viewport but not in another?
Thank you
