Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by douggroh
-
need help determing which direction to go in
Thank you all for your contributions. I will make my report accoringly.- douggroh
- Post #10
- Forum: Mechanical engineering general discussion
-
need help determing which direction to go in
Our materials are thicker and higher in the GSM than many nonwovens.- douggroh
- Post #6
- Forum: Mechanical engineering general discussion
-
need help determing which direction to go in
Thank you, Littleinch.- douggroh
- Post #3
- Forum: Mechanical engineering general discussion
-
need help determing which direction to go in
We have an assemly line that pushes material out at 4 meters per minute. We cut the material into blanks. Our guillotine chops the material to length, but it also stops it. If we could have the pull rolls sensing what tension is on the rolls, we could speed up the motor to make up the...- douggroh
- Thread
- Replies: 9
- Forum: Mechanical engineering general discussion
