Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by donegalforever

  1. donegalforever

    Tapered Shaft Connections

    I'll have a look. Thanks
  2. donegalforever

    Tapered Shaft Connections

    I was wondering if anyone knew where I could get formulae for calculating the capacity of a tapered shaft connection that also has a keyway? Any assistance would be appreciated. Best regards, Brian
  3. donegalforever

    PDF from multi page drawings

    Try www.cutepdf.com You can download a printer that makes pdf's and select the page you want to print from the print dialogue
  4. donegalforever

    Drawing and mating Chain Links

    Not too sure, if this is what you want, but if you check out: http://www.3dcontentcentral.com/3dcontentcentral/ There is loads of models/assemblies in it for SW. There is a model done of a chain, that you could probably adapt. I have used it a few times, and it doesn't move, but for...
  5. donegalforever

    Winch/Crane; Motion Compensation Control

    There is a winch control available that takes into account both wire length and winch tension. if you need any more info, you can email me: brian_leslie@dol.ie The program is widely used in the fishing industry for AutoTrawl systems, and is available for electric, and hydraulic winches. The...
  6. donegalforever

    Choice of Books needed

    I am a recent graduate engineer & in need of some books to help me. The subjects I need are:<br> Gear design (involute type)<br> Material Properties<br> Stress & deflection of a material due to an external load etc..<br> Any other recommendations would be appreciated.
See more

Part and Inventory Search

Back
Top Bottom