Call SKM, they recommended the PTW Lite, which is Fault Current and Coordination, but at $2000. Bit more than I wanted to spend. Any others? Also, anything that incorporates Arc Flash calcs?
Can anyone recommend a good software program for basic 'in-plant' fault current calculations. Money is tight so I need something below $1000, but it can be relatively basic as I will just be looking at 3 phase bolted faults. Please provide recommendations on the software and any comments about...
Can anyone recommend a software program for basic in plant Fault Current Analysis. Money is tight so I need something under $1000, just to do basic 480V 3 phase bolted fault calcs.
