Recent content by doctorjay

Thank you very much CodeJackal. That is exactly the information i was looking for. My A/I must have had a senior moment when we were talking about this. This solves everything. I read appendix W after reading your reply. It helps a lot.

i thank you both for the information but availability of the forms or where to find them was not my question. i was asking if using one or the other forms was okay or not and if so, which form would be best. i have filled out many U1-a's but have never needed an extension due to normal design...

i don't have enough space to properly describe a vessel on my U1-a form. is there a supplementary form such as U-4 or P-6 that i can use?

thanks everyone. you have been a lot of help. i guess i'm just stuck with a bunch of rod i probably won't ever use.

ASME II C, at SFA 5.28 addresses this somewhat but doesn't address the suffix "R". AWS A5.5 address this as low-hydrogen electrodes. From what I see, this is a 2.25CR/1MO used in a cold climate for equipment with high temp and high pressure application. Also that pre-heat and interpass temps...