Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by DNF

  1. DNF

    Etch/Mark Aluminum with laser

    Hello, I am trying to etch some text on some 6061-T6 aluminum. The results from this is not good. Does anyone know of another way one side of a part cut by laser could be marked? I need to idetify one side of a sheet from the other.
  2. DNF

    Dimensions on Sheet Metal Parts

    Hello, For laser cut sheet metal parts is it standard not to dimension out everything on a print? The reason I ask is because I just started a new job where they don't want all features on a part fully dimensioned on the detail drawing. This is completly diffrent from all my other jobs where...
  3. DNF

    Military Primer Spec

    Thanks for the help. I think that someone made a typo on a mil spec they were referencing but no one knew enuf to question it. After that it was used over and over again with know one knowing what it is.
  4. DNF

    Military Primer Spec

    No, All that I have is the calout they are using: "Prime per Mil-C-250 or equivalent"
  5. DNF

    Military Primer Spec

    Has anyone used or seen MIL-C-250 before? It is a finish spec for prime on a Aluminum part. I started a new job and they sware they use it but no one knows what it is and I can't find any info on it. Thanks for the help.
See more

Part and Inventory Search

Back
Top