For agitator in flathead vessels, we are considering using ASTM A108 material. Agitator shaft is used for low speed and low torque service. Can any one comment the suitability of this material. If this is not appropriate material, then suggest a suitable material.
For agitator in flathead vessels, we are considering use of ASTM A108 material. Agitator shaft is used for low speed and low torque service. Can any one comment the suitability of this material. If this is not appropriate material, then suggest a suitable material.
DMAB
We are designing ASME Sec VIII flat head vessels and need an agitator shaft to protrude out through head. ASME VIII does not address any material requirements for shafts etc.
Is Shaft an integral part of a pressure containment system or not . As per general engineering practices shafts design...
