Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by dleesukEB

  1. dleesukEB

    ELLIPTICAL CONTACT STRESS

    Thanks UncleSyd for your assistance anyway.
  2. dleesukEB

    ELLIPTICAL CONTACT STRESS

    Thanks UncleSyd Do you know of a UK distributor? Regards Darren
  3. dleesukEB

    ELLIPTICAL CONTACT STRESS

    Thanks and appreciation to all who have replied so far. [thumbsup] Darren
  4. dleesukEB

    ELLIPTICAL CONTACT STRESS

    Bradleyelwood, Thanks for the info regarding Hardox 500 We, as a company, have used Hardox 500 on a number of occasions for sub-sea 'scraper' blades on cable ploughs. I know it is a very hard-wearing material. The rails are definitely not structural and I am intending to bolt them to the...
  5. dleesukEB

    ELLIPTICAL CONTACT STRESS

    Thank you IONE. I have had a look and found some small snippets of info. Thank you KINGNERO. The material I was thinking about was HARDOX 500 (Swedish Steel).
  6. dleesukEB

    ELLIPTICAL CONTACT STRESS

    Hello All, I am currently designing a RAIL for a crowned roller to run along. I have been trying to find information on ELLIPTICAL CONTACT STRESS between the roller and the rail, to no avail. Using HERTZIAN stess calcs. gives me a certain figure when I use the radius of the roller and...
See more

Part and Inventory Search

Back
Top Bottom