Recent content by dkdragon

Can anyone offer any suggestions where to go for training in the use of insight connect?

I know you can do it using the hole table, is that what you are trying to do or are you trying to list all dimensions by co-ordinates?

Thank you, both replies were helpful.

I just pulled a dxf off of one of our suppliers web sites in dxf format. when I pull up the drawing (in dwg format) and try to get a diminsion between two holes it comes out in cm. In the dim style manager box, under primary units the unit format is Decimal. My question is how do I made my...

thanks very much I will give that a try, great posts by all I appreciate the response. Thanks, DKDragon

yes that is the only way I knew to do it also. I wanted to maintain my associtivity. When will version 15 be out? Any idea?

open your .dft file and do a save as, change the as file type to .dwg and it should come out fine. I usually get a message about proxy graphics but just click ok and dimensions and lines should show up correctly. I have done this on both version 11 and version 14 of solidedge. I hope this helps...

Is it possible when in the draft enviroment to create on hole table, on a seperate page for all of the previous views/pages. For example I am working on a 4 page drawing. I have a front, left , right, and top view. I want to add a page 5 with a hole table for all the previous pages. Any help...

ok guys thank you for the suggestions and I will try them and let you know how it goes. thanks, Dkdragon

Using solid edge 14 service pack 5. I get a grey arrow pointing to a cutout when I go back before that cut out and make a change to a profile I am getting this error message a lot. the cutout or protrusion that I get an error on seems to me to be non associative to the one I modify but I still...

this guy offers on site training and also classes. We have used him and were very pleased. Here is the link to his site. http://www.cadcamtraining.com/

Thank you swertel, that did the trick!

I just up graded SE11 to SE14 and the first thing I noticed was WOW, THOSE ARE SOME BIG OLE BUTTONS!! :-) Is there any way to make them smaller, I know that their was in SE11 but I either can't remember it or can't find it. Thanks, DKDragon

No offense taken, thank you for the explanation. This forum in my opinion is a very valuable tool and I just wanted to be sure I wasn't unknowingly abusing it. Thanks again, DKDragon

Thank you swertel, thats not the setting you can click to make it happen automaticaly, but i believe it will work just as well and I appreciate it. I have one more question for you,on the last 2 msgs that I have posted the replies i have gotten have said toward the end "Please see...