Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by dixietool
-
Creating attributes with Journal using stock size from PDW
cowski, thank you for the response, the bounding box that this journal creates is not accurate on components with an angle on one side. the "stock size" in progressive die tools toolbar gives the accurate size. is there a way to use that one in this journal and is it possible to do an entire...- dixietool
- Post #3
- Forum: Siemens: UG/NX
-
Creating attributes with Journal using stock size from PDW
Hello, I was wondering if anyone could help me create a journal that would create attributes like "thickness", "width", and "length" for components using the stock size from Progressive Die Wizard for each component that would be an attribute in each part of an assembly and also work on while...- dixietool
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
