Anyone else have issues with the hole wizard propagating to the components? In the assembly without propagating it works perfectly. As soon as I set it to propagate, the holes move into random locations even though they are fully defined in a 3D sketch in the assembly.
Yea I fixed the single pick issue in 0.2c
Take a look at the unit conversion method I used, you might like it better than what you have in your current file.
Have a great weekend!
Attached is version VBA 0.2c
Found what I missed ...
The tool tip is no longer working on my machine now though. No matter which way I flip the switch.http://files.engineering.com/getfile.aspx?folder=1027d7cb-1b8e-40bd-81aa-d67ad0adfd73&file=SmartMeasure_VBA_0.2c.swp
One thing I noticed the VBA version is not doing is showing the information of a single entity like the vsta version does. I must have missed something or not had all the code?
Attached is version VBA 2.0b
Sorry, dumb error is now fixed.http://files.engineering.com/getfile.aspx?folder=48351a79-61b0-45cc-a64e-08e28f4c9604&file=SmartMeasure_VBA_0.2b.swp
Attached is version VBA 2.0a
' Changelog:
' Rev 0.2a
' - Now pulls conversion and unit strings from the current Document units settings.
' - Moved unit conversion and identification inside measure it. If user changes document settings
' after macro is started, now will keep current with...
Here's a VBA version of the current release. Handleman, it might be useful for us to keep a running version so we know what is the latest. I've rev'd this file to 0.2, but it still does not have enough comments for my tastes...
I'll work on a back-to VBA version of what you have. I'd like to incorporate the changes you've made, but I'm going to stay with VBA so I can make my own edits easily. =P I'll post it when it's done.
I've got a lot of jobs on my desk, so it may be a bit before I get back to it.
Yes I've had plenty of problems running SW across two monitors on many different versions. I've personally never seen the need, I like having other stuff on my second monitor anyhow. I know that was terribly helpful. =P
Depending on what you are trying to do, you aren't likely to find much information around on nitinol. Most of the actual formulations are either proprietary or well guarded. Since the percentages of the constituents as well as any processing completely changes the properties of the material, any...
I tried running this in 2009 SP2.1 and it worked but never popped up the tool-tip style box beneath the cursor. It did show up in the bottom left of the status bar. It also is only showing mm measurements.
In one case I select a vertical line and a point, since these do not come up as parallel...
This is their latest attempt to manage their often terrible performance issues. Force the users to work in minimum program state. That's fine if the models would be remain completely representative of any and all previous changes made to them and then automatically resolve when something was...
Sounds like you are testing for high pressure fuel or hydraulic lines for aircraft. I'm not sure if they are competitors of yours or not, but Aerofit Products, Acra Aerospace and Airdrome Parts Company all make these kinds of fittings and perform this test in-house. They may be willing to either...
Can anyone point me to a specification or requirement for temperature and humidity control of inspection specifically for aluminum parts for the aerospace industry. We are primarily non-commercial which means that FAA requirements may not apply. If there are FAA requirements I would definitely...
