Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by dinoo3
-
Reciprocating compressor - discharge line check valve
Coleagues, What is the best solution for check valve at reciprocating compressor discharge line? Now there is installed stopcheck valve 1500 lb, 6 inch, whith pressure seal. 20 MPa op.pressure, fluid is hydrogen, op. Temp is up to 80 celsius. What is the best check valve for this services? This...- dinoo3
- Thread
- Replies: 4
- Forum: Petroleum engineering general discussion
-
Clamp connectors - Compatibility
Hi there, What is yours opinion about compatibility of clamp connectors which are made by different manufacturers? Especially Grayloc vs, Destec. Is possible insert Destec seal ring into Grayloc's hubs an clamps without problems? Are the same products, with same dimensions? What are the...- dinoo3
- Thread
- Replies: 5
- Forum: Petroleum engineering general discussion
-
"The Clamp Connectors"
Many thanks for yours answers and advices amd I will continue in this topic: I own the one unit for 15 years and most of total quantity of clamp connectors never been disassebmled. Do you think, that is necessary for some period to make total inspection as prevention for all clamp connectors at...- dinoo3
- Post #6
- Forum: Petroleum engineering general discussion
-
"The Clamp Connectors"
Hi there, I would like to improve reliability and safety of clamp connectors, because I don't have good experience with job of our on site service company. We have sevaeral GRAYLOC connectors (range 1/2" - 30") and after T/A we has some inspection findings such as "hub in poor condition -...- dinoo3
- Thread
- Replies: 6
- Forum: Petroleum engineering general discussion
