Please help! I have a power point presentation due Monday morning and i do not have the True Type AMGD&T font folder installed on my computer. I have googled it to no avail. Does anyone have the folder?
That wouldnt' work.
The round ended slot is 10mm +0.1/-0.0, my pin is 10mm
The end of the slot is my secondary datum, datum -B-.
I'm just going to add a clamp to apply 5 lbs of pressure to hold my pin in the radius of the slot F/A and call it that. Thanks for your help.
Let me try to explain this a little easier for you.
I'm working on a convertable top assembly.(lots of links and clevises) I have to attach the main pivot bracket, (5mm steel plate.) to the rear wheelhouse inner LT and RT. In each wheelhouse inner there is a weld pin fixture set for my main...
Are you saying that if one degree of travel is open on a datum feature, it's a gage process / standard to automatically add a clamp to restrict said range of free motion?
I am using a slot with rounded end as datum -B- , Dia 10 MM and my -C- datum is a target point on a trim edge. I would like to add a clamp note on the opposite side of part so -B- datum pin will not slide within slot. Basically i want the pin to stay nested in 10 MM rounded end of slot.
Do i...
