Ajack1, thanks for the input on getting started. As I said before, what has gotten me thinking about this again is remembering the job I had in college, helping out in the tool room of a local stamping mill. Right now, I work for a firm that designs mechanical, electrical and plumbing systems...
Good evening to everyone, for a while now I have been thinking about a change of direction. I have been working for an MEP design firm for the past several years. But I have recently been thinking about trying to move into tool and die design. I had a summer job working in a stamping mill...
Thanks for your help. It is a LEED project, so I will have to review those guidelines. What you mentioned is what I ended up doing, modelling the heat exchanger as a low efficiency boiler.
I am fairly new to using Carrier and I am having trouble figuring out if it is capable of modelling a building that uses campus steam and a heat exchanger for the building hot water. Is carrier capable of this, if so, how is it done? I am using version 4.34. Thanks
